SearchSearch
Call Us Today: (800) 633-8234

Catalog

Request Information
30 Ton Capacity can be used with Nos. 1126 and 1127 bearing pulling attachments or No. 680 pulley pulling attachments (two 8012 adapters are required to connect 680 to puller). Can be used with No. 1165 internal pulling attachment. Leg ends threaded 1 Inch - 14. No. 1109 legs and No. 28390 leg ends Included. Wt., 44 lbs.
Unit of Measure

Max. Reach

 N/A 10 1/2 inches

Max. Spread

 N/A 7 - 16 1/4 inches

Screw size

 N/A 1 1/2 - 12 x 17 1/4 inches

Thread Size

 N/A 5/8"-18

Weight

 N/A 44 lbs.

Ship Weight

 N/A 44 lbs.

N/A

Assembling the tool to apply pushing or pulling force:
1.Determine if you want the tool’s forcing screw to push or pull.
2. To exert pushing force, the forcing nut is installed beneath the cross block, as shown on left.
3. To cause the forcing screw to pull, the forcing nut is placed on top of the cross block.
4. The sliding plates must always be placed on the opposite side of the cross block from the forcing nut.

^