SearchSearch
Call Us Today: (800) 633-8234

Catalog

Request Information
Push-Puller with RT503 center-hole Power Twin cylinder, cylinder half coupler, P55 pump, 9767 6-ft. hose, 9798 hose half coupler, 24 Inch legs, 1 5/8 Inch - 5 1/2 x 30 3/8 Inch lg. adjusting screw and adjusting crank. Wt., 201 lbs. Leg ends-Leg ends are threaded 1 1/4 Inch 12 x 1 3/4 Inch lg.
Unit of Measure

Used With

 N/A Bearing pulling attachments:1128 and 1129. Legs:1112 and 1113-Pair of legs for 50 ton “capacity” Push- Puller.

Ship Weight

 N/A 212 lbs.

N/A

Assembling the tool to apply pushing or pulling force:
  • Determine if you want the tool’s forcing screw to push or pull.
  • To exert pushing force, the forcing nut is installed beneath the cross block, as shown on left.
  • To cause the forcing screw to pull, the forcing nut is placed on top of the cross block.

    • N/A Each Push- Puller’s specified tonnage “capacity” is determined using its standard legs in tension. Using longer legs, or a setup in which the legs are in compression, will reduce the “capacity”. Always select the largest “capacity” puller and the shortest legs that will fit the job.

    N/A This unique center-hole cylinder powers each Push-Puller. Puller screw runs right between the twin spring cylinder. A basic head allows you to change from a tapped hole to a plain hole by merely changing the head insert.

    ^