SearchSearch
Call Us Today: (800) 633-8234

Catalog

Request Information
Push-Puller with RT172 center-hole Power Twin cylinder, cylinder half coupler, P55 pump, 9767 6-ft. hose, 9798 hose half coupler, 16 1/2 Inch legs, 24827 leg ends, 1 Inch = 8 x 20 Inch lg. adjusting screw and adjusting crank. Wt., 59 lbs.Leg ends-Upper leg ends are threaded 3/4 Inch - 16. Lower leg ends are threaded 5/8 Inch - 18 Inch lg.
Unit of Measure

Used With

 N/A Bearing pulling attachments:1124 and 1130 Pulley pulling attachment:679 Internal pulling attachment:1154 Legs:1104, 1105, 1106, 1107 and 1108-Pair of legs for 171/2-ton “capacity” Push-Puller.

Ship Weight

 N/A 62 lbs.

N/A

Assembling the tool to apply pushing or pulling force:
  • Determine if you want the tool’s forcing screw to push or pull.
  • To exert pushing force, the forcing nut is installed beneath the cross block, as shown on left.
  • To cause the forcing screw to pull, the forcing nut is placed on top of the cross block.

    • N/A Each Push- Puller’s specified tonnage “capacity” is determined using its standard legs in tension. Using longer legs, or a setup in which the legs are in compression, will reduce the “capacity”. Always select the largest “capacity” puller and the shortest legs that will fit the job.

    N/A This unique center-hole cylinder powers each Push-Puller. Puller screw runs right between the twin spring cylinder. A basic head allows you to change from a tapped hole to a plain hole by merely changing the head insert.

    ^