MDI Manufacturing & Design Inc.
MDI Manufacturing & Design Inc.
7687 San Fernando Road
Burbank, CA 91505
Phone: 818.246.2300
Fax: 818.767.6469
Email: info@mdionline.net
Website: www.builtsystems.net
Print Back
10 Ton Capacity can be use with No. 1123 Bearing pulling attachment or No. 679 Pulley pulling attachment. May also be used with nos. 1150 and 1151, 1152, or 1153 internal pulling attachments. 1/2 Inch of forcing the screw tip end is threaded 5/8 Inch = 18. No. 1100 legs and No. 24827 leg ends included. Wt. 7 lbs.
Unit of Measure

Specifications

Max. Reach

 N/A 8 1/4 inches

Max. Spread

 N/A 2 1/8 - 7 1/4 inches

Screw size

 N/A 3/4 - 16 x 12 inches

Thread Size

 N/A 5/8"-18

Weight

 N/A 7 lbs.

Ship Weight

 N/A 7 lbs.

Tool Assembling

N/A

Assembling the tool to apply pushing or pulling force:
1.Determine if you want the tool’s forcing screw to push or pull.
2. To exert pushing force, the forcing nut is installed beneath the cross block, as shown on left.
3. To cause the forcing screw to pull, the forcing nut is placed on top of the cross block.
4. The sliding plates must always be placed on the opposite side of the cross block from the forcing nut.