MDI Manufacturing & Design Inc.
MDI Manufacturing & Design Inc.
7687 San Fernando Road
Burbank, CA 91505
Phone: 818.246.2300
Fax: 818.767.6469
Email: info@mdionline.net
Website: www.builtsystems.net
Print Back
Push-Puller with RT302 center-hole Power Twin cylinder, cylinder half coupler, P55 pump, 9767 6-ft. hose, 9798 hose half coupler, 18 Inch legs, 28390 leg ends, 1 1/4 Inch - 7 x 24 Inch lg. adjusting screw and adjusting crank. Wt., 102 lbs. Leg ends-Leg ends are threaded 1 Inch 14 x 1 1/4 Inch lg.
Unit of Measure

Specifications

Used With

 N/A Pulley pulling attachment:679 Bearing pulling attachments:680 (Use two 8012 adapters to connect to puller.) Internal pulling attachment:1166 Legs:1109, 1110 and 1111-Pair of legs for 30 ton “capacity” Push-Puller.

Ship Weight

 N/A 110 lbs.

Tool Assembling

N/A

Assembling the tool to apply pushing or pulling force:
  • Determine if you want the tool’s forcing screw to push or pull.
  • To exert pushing force, the forcing nut is installed beneath the cross block, as shown on left.
  • To cause the forcing screw to pull, the forcing nut is placed on top of the cross block.

    • Selection & Capacity Rating

    N/A Each Push- Puller’s specified tonnage “capacity” is determined using its standard legs in tension. Using longer legs, or a setup in which the legs are in compression, will reduce the “capacity”. Always select the largest “capacity” puller and the shortest legs that will fit the job.

    Power Twin Cylinder

    N/A This unique center-hole cylinder powers each Push-Puller. Puller screw runs right between the twin spring cylinder. A basic head allows you to change from a tapped hole to a plain hole by merely changing the head insert.